4 axis CNC controller TB6560 stepper motor driver board H type

4 axis CNC controller TB6560 stepper motor driver board H type
new type with manual control interface port

 

 

4 axis CNC controller board TB6560 stepper motor driver board for CNC Router Mill:

 

CNC stepper motor driver board TB6560  the new chip TB6560AHQ of TOSHIBA, the max ouput peak current can reach to 3.5A , this driver board can drive the 2-phase or 4-phase stepper motor whose current is less than 3A.

The advantages of the TB6560AHQ chip:

The vibration of the motor is small and low noise: because of the 2/8/16 resolution can satisfy the different speed. Flush type low heat: The area of the chip can support itself to cool when the current is low Supports a lot of stepper motors The advantages in the high-speed running condition

Features:

1.   With 3 wire 0.8-3.5A (peak) rated output of two-phase adjustable-current bipolar stepper motor drive

Support four microstepping ——1,1/2,1/4,1/16With optical isolation and DCDC power supply isolation, the full protection of your computer parallel port and equipment;Using RC +7414 automatic semi-flow,the current automatic reduce when stepper motor stop to down the heatSpindle relay output, easy to use software such as mach3 to control spindle start and stop.5 wire input control,it can set up limit,emergency,centred,tool setting etcWith manual port,and connect with manual control equipment12—36V single switching power supply,microchips to use as a 5V power supply, stable and heat smallInterface with a fan, you can add fan under your choice

 

Question and Answer:

 

Q1:why other supplier’s TB6560 driver has 3.5A/3A current,but yours is 2.5A?

A :TB6560 chip average output current is 2.5A,peak current is 3.5A,and can drive small than 3A stepper motor,ours 2.5A means the top average output current in real,also it is a long time security value,this is not design problem,it is according to the TB6560 chip self specification.

 

Q2:why some other type TB6560 driver board cheaper than yours?

A: (1):our board with high speed isolate optical coupler can through max 40MHZ pulse,and not lose step and skewing

   (2): With optical isolation and DCDC power supply isolation, the full protection of your computer parallel port and equipment in real,not spurious only with optical isolation

  (3)5V and reset use tantalum capacitors filtering wave what is better than electrolytic capacitor

  (4) our spindle can fit 10A replay

  (5) we use LM2567 microchip,low heat and enough power supply,more stable quanlity,and some other type use 78sereis common type

 (6) we use 5W cement resistance as feedback resistance,better heat performance and output drive wave than other board common resistance

 

Friendly Note:

It is not worthy to save small money to buy a driver board but broken mainboard or lose step and skewing when engraving.

 

 Package include:

1 x TB6560 Stepper Motor Driver board1 x DB25 parallel cable 1 x FanEnglish user manual will send by emailMACH2/3:http://www.artsoftcontrols.com, EMC2: http://www.linuxcnc.org